Commander 7100

Introducing the Commander 7100.


Free shipping within the Continental US.

Icom IC-7100 not included.   😉





Production has begun on the new Commander 7100… a complete, turnkey solution for the Icom IC-7100 


See the 90-second intro, here:


• 22 AH lifepo4 battery bank, built by us and covered by our two year warranty.

• Real-time power usage meter, shows & records voltage and min/max amps & watts of power draw.
• Two 3 watt full-range speakers, with defeat switch.

Front mounted headphone jack.  Run silent or run both speakers and headphones.

Microphone pocket for secure storage and internal connection.
• Internal 3 stage AC charge controller, worldwide voltage.
• Internal 3 stage solar controller, accepts up to 60 watts of solar power.
• Two panel mounted antenna extensions, mil spec, shielded RG400, made in the USA.
• Two 3 amp USB drivers for charging or powering other devices.
Front mounted stainless steel grounding lug, connected via a tinned & braided cable to copper lug.
• Two power poles on front for accessories.  20A distributed.  
• Head unit is a very secure ‘press fit’ into its stowage bay.
Head lifts out easily for operating outside the Commander.
• Fits in a fat 50 can. Waterproof when closed.
• Integrated power connection for radio with factory disconnect and two inline fuses.
• Tool-free installation and removal of radio.
• Ability to run the radio with the machine ‘dark’.




Our two-year warranty is the best in our industry and is only possible thanks to the quality of our gear.  If you have trouble with any of our equipment that we cannot resolve through phone support, ship us the machine and we will repair or replace and ship it back to you at our cost.



See the detailed product video, below:










Launch pricing will be in effect for a limited time, as we fill our component supply chain and get our bench technicians up to speed on building this new machine.  Please allow 2-3 weeks to receive your new Commander 7100.



We will ship your Commander to any domestic USA address for free.  Most shipments are FedEx Ground.  If you are outside the USA, just email or call the office at (931) 207-0079 and we will quote shipping for you.


Bookmark the permalink.


  1. Questions:

    1) Is the unit intended to provide EMP protection when enclosed in a closed 50 cal can?

    2) What is the weight of the unit including a 50 cal can and an IC-7100?

    What resources and parts are required to install the IC-7100?



    • 1. The Ammo can is EMP resistant, but not EMP proof. To make it extremely effective at resisting EMP, replace the rubber gasket with a metal braid or aluminum foil.

      2. The complete system, with radio installed, is 24.5 pounds.

      3. You need nothing but your radio. We even include the four pin molex and inline fuses for the power connection to the radio.

  2. Approximately how long will this keep an icom ic-7100 going assuming 10% transmit? 5% transmit?

    • Paul, The Commander has a 22 Ah LiFePo4 battery, with about 20 Ah available before under volt occurs. Depending on the wattage your 7100 is set for, run time is a minimum of several hours. We have customers running their rig all weekend with a reasonable tx duty cycle and lower watt transmitting.

Leave a Reply

Your email address will not be published. Required fields are marked *